|
|
|
| Numerical and Experimental Study on the inPlane Rotary Draw Bending Process of a ThinWalled Irregular Tube |
| ZHANG Qingqinga,LI Dayonga,PENG Yinghonga,b,XU Zhiweia |
| (a.School of Mechanical Engineering; b.State Key Laboratory of Mechanical System and Vibration, Shanghai Jiaotong University, Shanghai 200240，China) |
|
|
|
|
Abstract The inplane rotary draw bending process of a kind of thinwalled irregular aluminum tube was studied. Based on the software LSDYNA, a finite element model of rotary drawing bending process for aluminum tube was established, and its reliability was validated by experiment. An evaluation method was proposed to describe the channel distortion of the thinwalled irregular tube with harmonicashaped section. According to the simulation results, the variation laws of the irregular tube channels were revealed. The influences of bending angle, bending radius, clearance between module and tube, and friction on the formability were obtained. The results show that the outside channels are expanded and the inside channels become narrow after the tube bending, and the distortion degree of the channels exhibits a linear distribution. Increasing the bending radius can alleviate the channel distortion, while the bending angle, clearance between module and tube, and friction condition between module and tube have little effect on the channel distortion of the tube.
|
|
Received: 28 August 2009
Published: 29 April 2010
|
|
|
|
|
|
| [1] |
. Multi-Objective optimization of Forming Process for Auto-body Panel Based on Springback Control[J]. J. Shanghai Jiaotong Univ.(Sci.) , 2011, 45(11): 1673-1677. |
| [2] |
. Experimental Study of Shear Fracture on Advanced High Strength Dual-Phase Steels[J]. J. Shanghai Jiaotong Univ.(Sci.) , 2011, 45(11): 1695-1699. |
| [3] |
WANG Wurong1，2,YOU Jie2,ZHANG Xinpeng2,3,LI Shuhui2,LIN Zhongqin2
. Robust Design for Characteristic Part Stamping Based on Statistic Analysis of Variation of Material’s Property
[J]. J. Shanghai Jiaotong Univ.(Sci.) , 2011, 45(01): 1-0005. |
| [4] |
YU Ning1,LIU Yonggang2,ZHANG Zhibo1,ZHAN Hua2,ZHANG Jian2，JI Jingwen1. Mechanical Spectroscopy Characterization of Forming Property of Automobile Steel Sheets[J]. J. Shanghai Jiaotong Univ.(Sci.) , 2010, 44(05): 624-0627. |
| [5] |
GUO Chaoqun,CHEN Jun,CHEN Jieshi,XU DongkaiYU Xiangyu,BAI Yanchao. Numerical Simulation and Experimental Validation of Distortional Springback of Advanced HighStrength Steel Sheet Metal Forming [J]. J. Shanghai Jiaotong Univ.(Sci.) , 2010, 44(04): 468-0472. |
|
|
|
|
