海洋工程装备与技术 ›› 2023, Vol. 10 ›› Issue (2): 61-66.

• • 上一篇    下一篇

水下采油树闸阀及连接器关键测试技术及应用

刘 晓1, 2 , 张 宁1, 2 , 朱 伟3 , 李 森1, 2 , 刘程程1, 2 , 熊 涛3 , 李泽邦1, 2
  

  1. 1. 青岛海洋工程水下设备检测有限公司, 山东青岛 266237;2. 国家海洋设备质量检验检测中心(山东) , 山东青岛 266237;3. 重庆前卫科技集团有限公司, 重庆 401122
  • 出版日期:2023-07-02 发布日期:2023-07-02

Key Testing Technologies and Application of Gate Valve and Connector Used in Subsea Christmas Tree

LIU Xiao1, 2 , ZHANG Ning1, 2 , ZHU Wei3 , LI Sen1, 2 ,LIU Chengcheng1, 2 , XIONG Tao1, 2 , LI Zebang1, 2   

  1. 1. Qingdao Marine Engineering and Subsea Equipment Inspection and Testing Co . , Ltd . , Qingdao Shandong 266237 , China ; 2. National Center for Marine Equipment Quality Inspection & Testing (Shandong ) ,Qingdao Shandong 266237 , China ; 3. Chongqing qianwei technologies group Co . , Ltd . , Chongqing , 401122 , China
  • Online:2023-07-02 Published:2023-07-02

摘要: 作为水下采油树系统的关键部件, 水下阀门和井口连接器面临着极其复杂的海洋服役环境, 必须经过测试验证其能够满足相关标准和规范规定的开启关闭锁紧解锁密封承压承载等性能要求为充分模拟水下低温高压及复合加载的额定水深工况, 研究了基于 API Spec17D、 API Spec6A 标准的水下闸阀和液压井口连接器的关键测试技术, 提出了一套复合测试的方法程序和测试系统, 并顺利完成了对国产化装备的实验室测试应用

关键词: 水下采油树, 闸阀, 井口连接器, 额定水深, 复合工况, 测试方法, 应用

Abstract: As the key components of the subsea Christmas tree system, underwater valves and wellhead connectors are faced with extremely complex marine service environment, and must be tested to verify that they can meet the performance requirements of relevant standards and specifications for opening, closing, locking, unlocking, sealing, pressure bearing, load bearing, etc. In order to fully simulate the working conditions of underwater low temperature and high pressure as well as the rated water depth under combined loading, the key testing technologies of underwater gate valves and hydraulic wellhead connectors based on API Spec 17D and API Spec 6A standards were studied; a set of combined testing methods, procedures and testing systems were proposed; and the laboratory testing application of domestic equipment was successfully completed.

Key words: subsea christmas tree, gate valve, wellhead connector, rated water depth, composite working condition, test method, application